UC WIP (Bill Batzloff)

UltraCruiser Works in Progress

Bill Batzloff (Granbury, TX)
Click on picture to view larger image

Pattern, Part before cut and done	Front radius tabbed stops wrinkles	Just put them in the jig and assemble	Assembled in jig

Needs aileron now	Ten more RT. Side needed now	Parts on left will become like right side	Inside of four right

Outside rib four right	Two of these go in the left center section	Finally the Beam comes together	A and F to go

Angle method	They have to come off again	Paper patterns	End of side rail inside

These are wimpy without skin	Bend in soft jaws in vice	No back drilling this way	Two more sections to go
Next Page